Produkty

Band and nozzle heaters with mica insulation

 

We produce mica band heaters and nozzle heaters  for heating cylindrical surfaces or surfaces of non-round profiles according to the requirements of the client.  Recommended for heating surfaces with smaller dimensions and/or, on the contrary, large dimensions in cases of combining the wattage vs. voltage parameters when ceramic band heaters are not recommended due to technological reasons. They can be single-part or double-part according to the size of the heated area. Band heaters are produced according to the nature of the application with an inside heating area (shrinking) or with an outside heating area (expanding).

 

Specification

Minimum diameter of the nozzle: 25 mm

Wattage tolerance:  +10%/-10% (measured at working temperature).

Operating voltage:  12 V – 400 V

Sheath materials: AISI 304, brass, steel.

Maximum recommended watt densities for mica strips: 3-6W/cm(depends on the dimensions of the band, the working temperature and the material of the heated part).

Maximum recommended working temperature: 350°C

Optional radial, tangential or axial turning of the electrical connection.

Option to mount “K” and “J” type thermocouples.

Mica band heater and nozzle heater single-part:

07-band heaters-with-mica-insulation

Mica band heater, two-part:

Band heaters with mica insulation

Mica band heater with outside heating area (expanding) :

07-band heater-with-mica-insulation-c

  • Methods of electrical connection – band heaters with mica insulation – for download in PDF

band heaters_solid_outlets_2

band heaters_outlets_from_the_conductor

band heaters_for_terminal_box

061

Application hints

Before instalation of band heater, the cylindrical surface must be smooth without protrusions and completely free of grease, oxidized metal parts, and other impurities.

When instaling, the band heater must encircle the cylindrical surface with sufficient force. Tighten slightly after 15 minutes, 1 hour, and 8 hours of operation.